Burned out highlights? See how the Advanced Color Editor in Capture One Pro can alleviate that, and bring justice to your image‚Äôs feeling by recovering the details of the highlights.
A camera with a large dynamic range will allow you to better retain the details in both the shadows and highlights at the same time.
Not all camera manufacturers have realized the importance of having a large dynamic range, and images shot with these cameras are more likely to show clipped highlight details.
When working with a RAW file you do have the possibly to recover some of the clipped highlights details as all three color channels typically do not clip data at the same exposure level.
As you get to know your camera, you will learn how much overexposure an image can handle while it is still possible to recover all details. The benefit of doing this is to get brighter shadows and more headroom to open up the deep shadows without showing noise.
Sometimes, you end up with images where the highlights are too blown out and all attempts to recover the clipped data leads to strange looking colors close to the burned-out areas. Capture One Pro 6‚Äôs Color Editor can be the only solution to fix such false colors.
The image above was shot with a camera with a limited dynamic range. To the left, you can see the image straight out of the camera where the highlights are clearly burned out. To the right, you can see the image after the highlights has been recovered and the false colors fixed with the Color Editor.
Capture One‚Äôs High Dynamic Range tool is the tool to start with when fixing the burned-out highlights. As the image was shot with a camera with a limited dynamic range, there is very limited headroom for the highlights. I can barely recover the details and I get some false greenish color in the recovered zones.
To fix the false color, I‚Äôll use Capture One‚Äôs Advanced Color Editor. I‚Äôll make the correction in an Adjustments Layer as I don‚Äôt know for sure whether the false color also appear as a natural part of the image.
1. Add a new adjustments layer in the Adjustments Tool by clicking the ‚Äė+‚Äô icon.
2. Invert the mask as you want to make sure that you work on the whole image while setting up the right parameters for the tool.
3. Pick the false greenish color with the color picker.
4. Adjust the selection by checking the ‚ÄúView selected color range‚ÄĚ on.
5. Reduce the Smoothness slider and turn the hue a little towards the green color in order to isolate the false color.
6. Uncheck the ‚ÄúView selected color range‚ÄĚ and adjust the hue to a more yellow/brown tone.
7. Invert the mask and brush in the color corrections.